output:
  - platform: gpio
    pin: GPIO10
    id: sensor_vcc_pin

switch:
  - platform: output
    output: sensor_vcc_pin
    id: sensor_power
    # Zorgt dat de pin bij elke boot (ook na sleep) standaard UIT staat
    # totdat we hem expliciet aanzetten.
    restore_mode: ALWAYS_OFF

esphome:
  name: xiao-esp32c3-light-sensor
  friendly_name: XIAO ESP32C3 Light Sensor
  platformio_options:
    board_build.f_flash: 40000000L
    board_build.flash_mode: dio
    board_build.flash_size: 4MB
  on_boot:
    priority: 900
    then:
      - switch.turn_on: sensor_power
      - delay: 500ms # Iets langere delay voor stabiliteit van de sensoren

esp32:
  variant: ESP32C3
  board: esp32-c3-devkitm-1
  framework:
    type: esp-idf

logger:
  level: DEBUG

api:
  encryption:
    key: "IMbpaUOgYJWv7CbCDwNjkhPQYdDylPqulrXvHS5BOKg="

ota:
  - platform: esphome
    password: "68124e613de22b373413d37452777c49"

safe_mode:
  boot_is_good_after: 5s


wifi:
  ssid: !secret wifi_ssid
  password: !secret wifi_password
  ap:
    ssid: "Xiao-Esp32C3-Light-Sensor"
    password: "nNaTBzEaDn5g"

captive_portal:

i2c:
  sda: GPIO6
  scl: GPIO7
  scan: true

deep_sleep:
  id: deep_sleep_1
  sleep_duration: 10min
  # De ESP blijft 20 seconden wakker om te verbinden en te meten, daarna MOET hij slapen
  run_duration: 20s
  # Belangrijk: setup_priority zorgt dat hij ook gaat slapen als WiFi faalt
  setup_priority: -100

time:
  - platform: homeassistant
    id: esptime
    on_time:
      - hours: 23
        minutes: 0
        seconds: 0
        then:
          - deep_sleep.enter:
              id: deep_sleep_1
              until: "09:00:00"
              time_id: esptime

sensor:
  - platform: adc
    pin: GPIO2
    name: "Battery Level"
    unit_of_measurement: "%"
    # Update interval korter dan run_duration zodat hij zeker 1x meet
    update_interval: 10s
    attenuation: 12db
    filters:
      - multiply: 2.0
      - calibrate_linear:
          - 3.0 -> 0
          - 4.2 -> 100
      - clamp:
          min_value: 0
          max_value: 100

  - platform: bh1750
    name: "Lux"
    address: 0x23
    update_interval: 10s

  - platform: adc
    pin: GPIO3
    name: "Soil moisture"
    unit_of_measurement: "%"
    update_interval: 10s
    attenuation: 12db
    filters:
      - calibrate_linear:
          - 2.5 -> 0.0
          - 1.2 -> 100.0